当前位置: 主页 > 行业资讯 > >
硬盘检测命令:

n addition to note about basic Seagate F3 diagnostics below is step-by-step checklist for Seagate F3 drives examination:

 

  1. Check start of spindle motor by 2>U
  2. Make HDD resources backup (RoM, P-List, Non Resident G-List, Translator, Disk Fw, Overlays)
  3. Check heads ability for reading and writing (Sa vol 3 FID 0x181 – head 0, FID 0x182 –head 1)
  4. Check vol 3, FID 0x17a. Write zeroes if you see ‘Diag Err OE’ in terminal.
  5. Check Media cache – vol 3, FID 0x346. Fill it by zeroes if you see any message in terminal that mediacache is corrupt.
  6. Work with SA → Edit HDD ID (Terminal). Switch off all flags except first one (“Show additional diag msg in terminal”).  If drive stays in BUSY don’t forget to set “Terminal” in Utility status.
  7. Clear DOS config tables by 7>m100
  8. Check Non Resident G-List by T>V40 command.
  9. Check G-List by T>V4. A lot of entries by one head  → damaged head. G-list overflow  → clear by T>i4,1,22. “Diag err” message in terminal …  → clear by T>i4,1,22
  10. Reset SMART, if there are no problems with heads and wide BAD-areas
  11. Initial translator diagnosis by T>V1. Output should not be empty. Both copies have to be readable (vol 3 fiD 0x28).
  12. Translator issue (user area can only be read before certain LBA). Run “Recover translator” tool, if it will give an error check this article.
  13. Contact ACE Lab Technical Support team

服务内容

服务特色

  • 免费咨询 免费检测
  • 免费咨询 免费检测
  • 免费上门取盘(限市内)
  • 服务器故障免费上门检测
  • 服务器数据恢复提供上门服务
  • 数据恢复不满意不收费
  • 提供涉密数据透明式恢复
  • 软件故障1-2小时内解决
  • 提供远程数据恢复服务
  • 硬件故障当天完成
  • 百级无尘环境开盘 数据当天可取
  • 借助软件手工提取不连续碎片文件